$575 – $1920
After our very popular 3 inch Cinematic EVA bumper BumbleBee and Green Hornet CineWhoop series, we were trying to increase performance and reduce weight for an even better and longer flight experience for a wide variety of use.
Our all new 3.5inch project is finally ready for all you content creators or those guys who like to wear some protection every now and then. Prop protection is what we’re talking about here…
ProTek is not necessarily just a Cinewhoop series but far more. Equipped with our all new 2203.5 motors for more power and less heat. We were able to increase speed and thrust by 50% compared to it’s 3inch predecessor which gives a lot more room for a lot more fun. Our GPS measured maximum speed was above 120km/h and a maximum thrust of 750g per motor (3kg in total) would even carry heavier cams than a Gopro but also do some loaded punch outs or light freestyle moves.
A lot of thought was put into the different assembly options. Our stock BNF will ship in the standard configuration but you can either do a pusher mod (flip the build upside down) or a lite mod (remove the protective plastic for weight optimization).
Durable plastic protectors with copper standoffs, portable compact design, easy accessable UBS port without disassembly, LED battery status, lost model buzzer and a universal GoPro TPU for a full size or naked GoPro. If you wanna go extra light, get one of our 5V balance plug GoPro power cables to get rid of the internal battery.
Flight Controller: Beast F7 AIO
Blackbox: 8Mb Onboard Flash
BEC output: 5V 2.5A
FC Firmware: IFLIGHT_F745_AIO
Mounting pattern: 25.5 x 25.5mm φ3mm
Dimensions: 32.5 x 32.5mm
ESC: 45A 2-6S
Current Sensor: Yes
Input: 2-6S Li-Po
Current scale: 200
Constant: 45A / Burst: 50A
RPM-Filter ready: Yes (JazzMaverick or JESC firmware)
ESC Firmware: BlheliS G-H-30
Mounting pattern: 25.5 x 25.5mm/Φ3mm
Dimensions: 32.5 x 32.5mm
1 x ProTek35 Frame
1 x DJI Digital HD FPV Air Unit (FPV Camera + Air Unit Module)
2 x DJI FPV Air Unit Antenna SMA
1 x TPU Bracket for DJI Air Unit Module
1 x TPU Antenna holder for DJI antenna
1 x iFlight Lipo Strap 15 x 150mm
1 x iFlight Lipo Strap 15 x 250mm
2 x Nazgul 3535 propeller (Set of 4 – Color May Vary)
1 x GoPro TPU bottom stand black (GoPro Protector not included)
*DJI HD FPV Goggles
*DJI Remote Controller (Mode 2)
The DJI Remote Controller is recommended for beginners since you won’t need to set up another receiver, but it is also optional in this BNF drone because it is NOT required in order to use the FPV system. If you don’t choose to use the DJI Remote Controller, you can choose a receiver option for your transmitter and then bind to your own radio as usual.